Normal
Operation -
The Epson Chip Resetter YXD268 has specially designed slots to accommodate the different
Epson cartridges. The pins in the Epson Chip Resetter YXD268 should tightly contact the
gold pads on the cartridge chip. When the pins are in contact with the cartridge chip pads
the led will blink red for 3 to 4 seconds, then LED will stay green. This indicates that
the reset has been successful. The plastic adapter is used only for the cartridges listed
below.
Resetting a C70/C80/C82/2100/2200 -
Attach the plastic adapter to the Epson Chip Resetter as shown in the photo. Rest the
cartridge on the plastic adapter so the pins on the Epson Chip Resetter line up with the
gold pads on the cartridge chip. Press the cartridge against the pins to make firm
contact. Hold this position for 3 to 4 seconds until you get a steady green LEDon the
Epson Chip Resetter. This indicates that the reset was successful.
| Troubleshooting - | |
| 1. | The LED on the Epson Chip Resetter does not flash. a) The pins are not making solid contact with the cartridge chip. b) The cartridge chip is not a compatible Epson chip. c) The cartridge chip has corrupted data in it, or it is defective. Get a new chip, or transfer a known good chip from an Epson cartridge. d) The Epson Chip resetter internal batteries are dead. This is unlikely, unless used over 1000 times. |
The Printer Filling Station is a division of Faith Unlimited Inc